FREE
AKTU Power Electronics Lab (BEE653) Syllabus PDF – B.Tech 3rd Year
Power Electronics Lab BEE653
All syllabus, notes, question bank & PYQ for this subject
Free
Download now
- English
- Semester 6
- 0 downloads
- 0 views
Official AKTU syllabus of Power Electronics Lab (BEE653) for B.Tech 3rd Year – 1 credits, L-T-P 0-0-2. Read the unit-wise course content, course outcomes, evaluation pattern and recommended books online, or download the PDF.
Syllabus — Power Electronics Lab
Download PDFBEE653 · 1 credits · L-T-P 0-0-2
Pre-requisites of course: Basic Electrical Engineering, Network Analysis & Synthesis
Course Outcomes
Upon the completion of the course, the student will be able to:
| CO 1 | Demonstrate the characteristics and triggering of IGBT, MOSFET, Power transistor and SCR. | K3 |
| CO2 | Analyze the performance of single phase fully controlled bridge rectifiers under different loading conditions. | K4 |
| CO3 | Develop simulation models of power electronic circuits. | K5 |
KL- Bloom’s Knowledge Level (K1, K2, K3, K4, K5, K6) K1 – Remember K2 – Understand K3 – Apply K4 – Analyze K5 – Evaluate K6 – Create Note: Minimum 10 experiments are to be performed from the following list:.
- To study triggering of (i) IGBT (ii) MOSFET (iii) power transistor
- To study V-I characteristics of SCR and measure latching and holding currents.
- To compare the R, RC & UJT trigger circuit for SCR.
- To study the commutation circuit for SCR.
- To study single phase fully controlled bridge rectifiers with resistiveand inductive loads.
- To study single phase fully controlled bridge rectifiers with DC motor load.
- To study three-phase fully controlled bridge rectifier with resistive and inductive loads.
- To study single-phase ac voltage regulator with resistive and inductive loads.
- To study single phase cyclo-converter
- To study the four quadrant operation of chopper circuit
- To study MOSFET/IGBT based single-phase bridge inverter. Software based experiments (Scilab/MATLAB or any equivalent open source software)
- To obtain the simulation of single phase half wave controlled rectifier with R and RL load and plot load voltage and load current waveforms.
- To obtain simulation of single phase fully controlled bridge rectifier and plot load voltage and load current waveform for inductive load.
- To obtain simulation of single phase full wave ac voltage controller and draw load voltage and load current waveforms for inductive load.
- To obtain simulation of step down dc chopper with L-C output filter for inductive load and determine steady-state values of output voltage ripples in output voltage and load current. Text/Reference Books:
- M.H. Rashid,"Power Electronics: Circuits, Devices & Applications", Pearson Education
- D.W. Hart, “Introduction to Power Electronics” Prentice Hall Inc.
Ratings & Reviews
No reviews yet — share your experience with this item.