AKTU Network Analysis and Synthesis Lab (BEE451) Syllabus PDF – B.Tech 2nd Year

Pre-requisites of course: Basic Electrical Engineering

Course Outcomes

At the end of this course students will demonstrate the ability to:

KL- Bloom’s Knowledge Level (K , K , K , K , K , K ) K – Remember K – Understand K – Apply K – Analyze K – Evaluate K – Create

List of Experiments

Ten experiments to be performed:

1. Verification of Maximum power transfer theorem.
2. Verification of Tallegen's theorem.
3. Study of phenomenon of resonance in RLC series circuit and obtain resonant frequency.
4. Design and find cut-off frequency of low pass and high pass filters.
5. Design and find the pass band frequencies of band pass filters.
6. Design and find the stop band frequencies of band reject filters.
7. Determination of two port network Z and h parameters.
8. Verification of parameters properties in interconnection of 2, two port networks in series-series interconnection.
9. Verification of parameters properties in interconnection of 2, two port networks in parallel-parallel interconnection.
10. Determination of Z parameters of a T network and Computation of corresponding parameters to equivalent π network.
11. To perform the transient response of RL circuit.
12. Verification of parameters properties in interconnection of 2, two port networks in cascade interconnection. Note: Any two experiments from above list should also be performed by students on Virtual Lab.